I tried wir 2.2A Motor Current. Motors run a bit hot during print. Wasn‘t diffrent.
Also, I tested diffrent motors w/o changing the issue.

Next week I will get a new Power Supply with 24v to change the whole system to this voltage.

I will reply my experience

I´ve just tried two other servo´s, these ones run fine like accepted.
They are much cheaper than the 1st one. I have to check the wire.

Thanks

@dc42 said in BLTouch + additional servo:

mean PWM4

I mean PWM4

using that servo
Savox SC-0254MG

like this over command line:

M280 P1 S150

I´m trying to set an servo for my tool changer (something like Prusa MMU) but the config for servo isn´t that easy for me.

My Setup:
Duet Wifi
Duex5
BLTouch
miniServo

• BLTouch is running for Z-probe and connected to Heater 5 of duex5
• the servo I´d like to control is connected to Heater 4 of duex5

The BLTouch is running in z probe w/o any issues but the other servo doesn´t move if I want

M950 S0 C"duex.pwm5"                    ; create servo pin 0 for BLTouch (default from Config Tool)
M950 S1 C"duex.pwm4"                    ; additional servo                        

I guess my thinking isn´t correct. Please help me to understand how it works

sounds good, thanks

thanks

is it possible to use a 12V Fan on DuetWifi if main voltage is 24V?

I have read an older topic and in that topic was described if I use 12V fans only I can take off the V-Fan Jumper and can connect +12V direct to the middle pin, is it right?

any suggestions?

yes, the toolbuttons ar in front of the macros. But if I press one of the Tools 2 till 5 the macro button is pressed insted of the tool