heres the pics

So I have a 24v berdair hooked directly up. I usually run at 25 to 30% and have the Pam set to 255khz.
The motor get rather warm. Almost to hot to tuch. Should I be concerned?

One thing noticed is with the panel.due there is no " on the onscreen keyboard. Kinda make it hard to setup wifi with it

It was I had checked it like 3 times but the 4th showed the y axis pulley was loose.

interesting. i didnt think of that. how would i check it? it happen during bed probing cycle

so this has poped up a few times. keep getting a random heater fault. i thought it was the old heater chartrage or thermsistor. so i replace the 30w heater with a new 40w and a new heat block, thermsistor, nozzle and heat break.
it happen again. it didnt seem to want to try to heat the heater after i stopped the print and homed the machine

any idea why this happens? frist time with the new heater

@samlogan87 thank you for the reply. We have the bed leveling working. The problem is were getting inconsistent probing. Are you saying that it could be because each motor is out of sync of some sort?

Update. Still having problems with probing with the precision piezo
At first we thought it was the boden tube causing a error so we removed it. Didn't help
Hoping the piezo guy could help with this.
We reduced the probe speed aswell but no avail.

So I have a extra duet wifi bord I been trying to figure out what to do with.
So I have been looking at building th mpcnc as a 4x4 plasma table. I was pondering if the duet could be configured to work with a torch height controller like this one
http://proma-elektronika.com/index.php/en/products/thc-torch-height-control/compact-thc-150
It has 3 outputs that should be monitored. Up down and ark ok

Looks like prusa released a promotion video
https://youtu.be/E1ZxTCApLrs

Maybe the mosaic setup might be better for a duet 3. Which I think I heard is supposed to have a USB host?
What about the prusa multi material mk2? I think it communicates over spi or can bus and is half the price?

Has there been any thought given to being a leader to implement either of these options? I know the filament sensor would likely be a requirement for the Prusa multi material.

So we got it up and running. Were having a weird increasing z offset each time we probe. Any ideas?

Looks like the marlin guys are working on getting the panel due going for their firmware
https://youtu.be/QJx75PWE6dQ
At 13:20ish