suche deutschen support für einen selbstentwickelten Großformat 3D-Drucker mit 4250 Watt DUET2 WIFI-Board. Sitze hier in München und bekomme meine PT100 daughter-boards bzw. die Heizbetten nicht angesprochen...könnte auch bei den anderen Configurationen Hilfe brauchen...)
Best posts made by axiom
-
suche deutschen support Großformat 3D-Drucker DUET2 WIFI-Boardposted in Firmware installation
-
RE: Printing speed just slow motionposted in Using Duet Controllers
@Phaedrux
I deleted all 4 lines... and what can I say... amazing speed!!
Thank you both
Many greetings,
DonPS: New puzzles are just appearing again (progress display and filament consumption...but first the printer is running and I can devote myself to the insulation and construction space closure)
-
RE: 2 PT100 daughterboards for the bed heaters, Code?posted in Firmware installation
@günter-jibben Danke für den Tip!....da passt ja grad mal ein kleines Foto rein!
-
RE: Raspberry Pi 5 does not support Octoprintposted in General Discussion
@PCR because I want to do live surveillance with a camera and not just individual images
-
RE: want to center the sample with G1 Z1 (mesh bed compensation)posted in Using Duet Controllers
@gloomyandy I actually got that wrong! Thank you very much and then I will follow the new instructions.
All the best! -
RE: Z motors need more powerposted in Duet Hardware and wiring
@axiom Thanks to both of you! That seems to have been the solution!!!
Best regards -
RE: Control printheads individuallyposted in Firmware installation
@cosmowave It works! Thanks, that was the solution!
-
Auto Z offset calibrationposted in Using Duet Controllers
I found a promotional video and I would like to know how to do it: hardware and macro...can anyone help me?: https://www.youtube.com/watch?v=yJo_1Op2g4Y
-
RE: z probe not referencedposted in Firmware installation
@jay_s_uk you are super! it works... thanks for your patience!
-
RE: nozzle dives almost 4 mm too deep into the bedposted in Using Duet Controllers
@Phaedrux I think I was able to partially solve the riddle: I thought the M561 command would also delete the trigger values in config.g. You have to manually set the trigger value G31 of Z to 0 before the trigger test. The second thing I did is physically decrease the distance of the sensor. The disadvantage of a capacitive sensor is that the heat from the bed will greatly reduce the life of the sensor. So I'll be looking for a new sensor system in the long term...I've started reading about the piezo technology, but I suspect that the one on my Volcano hotend is too big...but in any case, the printer is running reasonably well now... ..just to understand: Are the values after the mesh bed compensation automatically taken into account during the job and are the unevenness compensated?
-
RE: printer prints the job mirroredposted in Using Duet Controllers
@Phaedrux with a little delay i now understand what is meant... i exchanged the x and y axes and endstops on the board and also in the code and now everything seems to be ok... thank you very much!
-
RE: activating z-babystepping before job runsposted in Using Duet Controllers
@Phaedrux Worked great! Thank you Phaedrux!!!!
-
RE: reference the X-axis on both railsposted in Using Duet Controllers
@axiom So, the campaign was a complete success!!! Thank you Frederick