printer prints the job mirrored

[axiom]

Although everything looks correct in the slicer (Cura) in the preview, theCCR10_KettenaufnahmeV1.gcode printer prints the job mirrored,
what can be the reason?
Attached is the g code

[Phaedrux]

Usually this happens when you have one axis going the wrong direction.

The slicer assumes you have -x to the left, +x to the right, -y to the front, +y to the back. Can you confirm that?

[oliof]

@axiom what kind of motion system isnyiur printer using?

[axiom]

@Phaedrux yes, i could confirm that

[axiom]

@Phaedrux With negative values, the y-axis moves to the left in the direction of the starting point. the x axis with negative values ​​also to the left in the direction of the starting point. But the question is what to understand as front and rear

[axiom]

@oliof said in printer prints the job mirrored:

motion system

it s a cartesian

[axiom]

@Phaedrux with a little delay i now understand what is meant... i exchanged the x and y axes and endstops on the board and also in the code and now everything seems to be ok... thank you very much!