Topics created by Armatus

At that age the warranty is passed, but if you post some close up well lit photos of the board we might be able to see if a chip was damaged that could potentially be replaced. I suspect something was amiss with the LCD wiring maybe causing a short? But if the fuses are all intact, and no signs of damage or any components getting hot and all LEDs light up then I'm not sure.

I've currently connected all the non-button related LCD pins to try to get the screen to turn on when the printer is powered on and show something, nothing so far. Flipped the connectors in the LCD, still nothing. I'm running the latest Duet firmware and RRF configurer. I've modified my config file with the following:

M575 P1 S1 B57600
M918

Using this as a wiring guide for the LCD: https://wiki.fysetc.com/Mini12864_Panel/

What am I doing wrong here?

I took the lazy way out and just designed my own Z-stop switch, didn't like the tool head Z-stop either. It's only a 150mmx150mm bed and it's super flat, being all manual will be fine. Thanks for everyones help 🙂

IMG_3256.jpeg
IMG_3257.jpeg

I've run ~25 pounds of filament through this printer in the last 3 weeks, so far I've only had two failed prints both resulting from bed warping. I'm going to invest in a removable springsteel PEI sheet next to help with that. Here's a few parts:

0_1548716282487_fullsizeoutput_aef.jpeg 0_1548716303359_fullsizeoutput_ae0.jpeg
0_1548716324976_fullsizeoutput_ac6.jpeg

Loving my duet hardware ❤

I'm making progress, had to reconfigure the firmware from scratch and re-upload. I still have a lot of settings to tweak and an additional axis to wire up and get working, but I do have one nozzle printing now 🙂