Robo3d R1 Plus AutoLevel
-
Yes the z probe reads 1000 not 100. Sorry for now being nore clear the x axis crashes into the end of the rail opposite of the endstop. Usually dies this right before a print starts. I will use your recommendation and adjust the settings fir this.
Your concern. About the probing of the bed is valid as its a problem that plaugues the robo3d r1 plus. I will manual level it again to try to ease this a bit.
I have tried contacting the author of that thread but havent heard back. -
Just to clarify... All axis home properly.
The x axis crashes into the left of the gantry before beginning a print. or when I run this
" G1 X0 F1000 then it moves the head to the left hand edge of the bed" -
The auto level is not going to the back of the bed here is a video( you can fast forward to 1min 40sec) https://www.youtube.com/watch?v=NDrzoygZaHA
-
I fixed the X axis cashing issue... Problem was in the gcode, G1 X0 instead of G1 X15. Now it no longer crashes.
-
I'm glad you managed to fix it. Are the problems you reported at the start of this thread resolved now, or do you still have a problem with Z probing?
-
Itstill does not go to the back of the bed for auto level everything else is ok for auto level. Now I am having issues with the heated bed causing prints to cancel but I will start a new thread fro that problem
-
The reason it isn't going right to the back is that it will omit any probe points that would put the nozzle outside the reachable area set by your M208 commands. Assuming that the back of the bed is max Y, you may need to increase your M208 S0 Y parameter a little to that the nozzle can move as far back (or the bed as far forward) as physically possible.
-
Thanks ill give that a try
-
I am still having some issues. It is printing too high in the front right to middle right of the machine. Everything else is a perfect layer. I was wondering If there is something I can do to fix this?
-
Get a proper Z probe and use mesh grid compensation.
-
@sleepless said in Robo3d R1 Plus AutoLevel:
I am still having some issues. It is printing too high in the front right to middle right of the machine. Everything else is a perfect layer. I was wondering If there is something I can do to fix this?
If the amount by which the bed gives before triggering the microswitch varies with XY position, then I suggest you make the bed more rigid or use a Z probe that applies less force the the bed before it triggers.
-
OK I WILL LOOK INTO ADDING A BLTOUCH