Setup Issue

nickt

I have exactly the same problem ,
ls /dev/tty.*
it says
" no such file of directory "

total stuck guess i need to borrow a PC ??

briskspirit

ok, lets try: ls /dev/tty*

if nothing, then: system_profiler SPUSBDataType

brisma

@nickt try with sudo ls /dev/tty.*

nickt

thanks for the info , i have put the results below......

system_profiler SPUSBDataType
No such file or directory

system_profiler SPUSBDataType

Vendor ID: 0x0a5c (Broadcom Corp.)
Version: 1.00
Speed: Up to 12 Mb/sec
Manufacturer: Apple Inc.
Location ID: 0xfa110000 / 3
Current Available (mA): 500
Current Required (mA): 94
Extra Operating Current (mA): 0
Built-In: Yes

            Bluetooth USB Host Controller:

              Product ID: 0x821a
              Vendor ID: 0x05ac  (Apple Inc.)
              Version: 0.42
              Speed: Up to 12 Mb/sec
              Manufacturer: Apple Inc.
              Location ID: 0xfa113000 / 6
              Current Available (mA): 500
              Current Required (mA): 0
              Extra Operating Current (mA): 0
              Built-In: Yes

sudo ls /dev/tty.*

Password: ( then a key symbol )

dc42

So what happens if you then enter the super user password?

nickt

Out of interest can i set up the wifi if i plug the duet lcd screen in ?

dc42

Yes, if your PanelDue is running recent firmware that includes the Shift key on the touch keyboard, then you can send the M587 wifi setup command command from it.

kwhitehouse68

@briskspirit

Last login: Sat Oct 6 15:32:57 on ttys000
MacBook-Pro:~ kwhitehouse$ ls /dev/tty.usbmodem1411
/dev/tty.usbmodem1411
MacBook-Pro:~ kwhitehouse$

kwhitehouse68

@dc42

Ok I have discovered the issue was me not entering the commands properly. Now my problem is that I hit the erase button while troubleshooting as per a forum thread and I think I probably need to reinstall something onto the board before it will connect. I found this thread, but it seems to be specific to windows:

https://duet3d.dozuki.com/Wiki/Installing_and_Updating_Firmware

I have considered boot camping Windows on my mac or trying to use my raspberry pi with raspian on it to configure the board, but this seems unnecessary. If you could point me in the right direction for reloading the firmware to the board and getting to the point where I can start over at the setup procedures again, I would appreciate it.

T3P3Tony

@kwhitehouse68 if you erased the firmware you will need to use fallback procedure #3 on the documentation page you linked.

I don't have a Mac however there are instructions at the bottom of the section about how to use bossac to upload an image to the board.