Hi, I pushed a PR for the italian language

Hi, I pushed a PR for the italian language

Try with Cura 4.5.0, the new official version 4.6.0 seems bugged.

Hi David,
I was wondering if it was possible to implement a confirmation dialog (maybe in the paneldue/dwc) now that we have some type of logic gcode.

I was thinking about a simple custom Confirm/Cancel dialog
For example, if filament runout, a confirmation dialog appear to assist the unload/load of the filament.

The best will be if the buttons can be customized to stop/continue the gcode or call macros.

Can be an idea?

M566 X480.00 Y480.00 Z30.00 E10000.00 ; Set maximum instantaneous speed changes (mm/min)

166mm/s of jerk on extruder? Try lowering to 600 (10mm/s)

M906 X1400.00 Y1400.00 Z900.00 E1428.00 I30

Why 1428 (that's useless) and not 1400 on extruder?

Are you on direct or bowden system? Can you try a print without PA?
Just comment this line:

; Pressure Advance
; M572 D0 S0.05 ; Enable pressure advance and set it. Marlin setup used a K of 0.03-0.05. HatchBox Wood K=0.03.

The size is correct... very strange

I've a custom HEVO, printed with PLA at 200/60°C at maximum 60mm/s with this config:

M350 X16 Y16 Z16 E16 I1                            ; configure microstepping with interpolation
M92 X80 Y80 Z400 E860                              ; set steps per mm
M566 X600 Y600 Z120 E900                           ; set maximum instantaneous speed changes (mm/min)
M203 X15000 Y15000 Z600 E1800                      ; set maximum speeds (mm/min)
M201 X1000 Y1000 Z240 E5000                        ; set accelerations (mm/s^2)
M906 X1300 Y1300 Z1300 E1300 I30                   ; set motor currents (mA) and motor idle factor in per cent

Edit:
DuetWifi with RRF 3.01RC9

Same problem to me with a custom HEVO on PrusaSlicer 2.2.0.
Now I'll retry with Cura 4.6...

@Leblond Certo, ma ripeto: sei su un forum inglese dove si parla inglese. Se non lo conosci e non hai voglia di impararlo almeno sforzati di usare il traduttore anziché scrivere in italiano.

Sorry for the OT.

@Leblond Mah guarda, sono italiano anch'io... eppure leggo e scrivo in inglese, basta avere la voglia ed il tempo di impararlo

In ogni caso, aggiorna prima a 3.0 usando questa guida:

https://duet3d.dozuki.com/Wiki/RepRapFirmware_3_overview#Section_Summary_of_what_you_need_to_do_to_convert_your_configuration_and_other_files

Ricorda che è un forum inglese.

A che versione vuoi aggiornare? Se sei su una 2.0x devi prima aggiorare a 3.0, poi aggiornare a 3.0.1.

@nickt try with sudo ls /dev/tty.*