Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    Pt1000 Help

    Scheduled Pinned Locked Moved
    Duet Hardware and wiring
    2
    3
    626
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • warbunniesundefined
      warbunnies
      last edited by

      So I'm a bit stumped and would appreciate some help.

      I attached a pt1000 sensor for my extruder to my duet ethernet & used M305 P1 X501 R4700.

      My sensor is saying that the ambient tempt of my hot end is 150C... which is not right.

      The only thing that got it to run temp was M305 P1 X501 R4700 T1098 but I tried turning the heater on and the temperature started dropping... so that's not right.

      What should I try next?

      1 Reply Last reply Reply Quote 0
      • dc42undefined
        dc42 administrators
        last edited by

        Which firmware version are you using? PT1000 sensors were first supported in firmware 1.20, and some minor bugs in the PT1000 support were fixed in 2.0.

        Duet WiFi hardware designer and firmware engineer
        Please do not ask me for Duet support via PM or email, use the forum
        http://www.escher3d.com, https://miscsolutions.wordpress.com

        1 Reply Last reply Reply Quote 0
        • warbunniesundefined
          warbunnies
          last edited by

          ah... that would have been my mistake. I thought I had a later fw than I did. that seems to have fixed it.

          1 Reply Last reply Reply Quote 0
          • First post
            Last post
          Unless otherwise noted, all forum content is licensed under CC-BY-SA