Can a short from the heater wires damage the board?
-
Apparently there was a contact between the wires and my printer doesn't connect anymore (web control).
Is my board finished or is there some hope?
-
@nylkos If it was only the bed heaters, the worst I would expect would be a blown heater mosfet, but you are saying all control is lost ? So what else was shorted out ??
-
@nylkos said in Can a short from the heater wires damage the board?:
Apparently there was a contact between the wires and my printer doesn't connect anymore (web control).
Is my board finished or is there some hope?
When power is applied, does the green 3.3V LED light up? Does anything on the board get hot?
