After 10/15 layers…. this error....

peirof

Hi,

i have try to print the piece 3 times, with the same results…. i can read in the console;

[[language]]
Error: Heating fault on heater 2, temperature excursion exceeded 15.0°C
Resume-after-power-fail state saved
Printing paused
Cancelled printing file 01 Carcasa Delantera.gcode, print time was 0h 43m
Error: Shutting down due to un-cleared heater fault after 600 sec

I have changed termistor and heater cartridge… but the same, after some layers....

in [c]config.g[/c] i have this line

[[language]]
M305 P2 T100000 B4138 C0 R4700 ;Set thermistor + ADC parameters for heater 1

Ideas?
The calibration temp…limit the print temp....? i want say

If i have calibrate to 235º and after i print, PETG, to 238º.

A- This can the cause of error?
B- Is normal print 10 layers, aprox, and after the fault?

dc42

https://duet3d.dozuki.com/Wiki/Spurious_heater_faults_and_how_to_avoid_them