Toolchanger Setup Continue...

[Chriss]

Hi *,

My toolchanger setup goes forward slowly, the hardware is mostly done now and I think about the configuration.
I wounder now where I should expect x0 y0. I see it at the moment at the z-endstop on the coupler.
My idea was to use that as the startpoint and set the offset than per tool. Or would it make more sense to use T0's nozzle as y0 x0 and configure the offset of the endstop and the three 0ther tools from there?

I'm not sure what would make more sense. My uneducated guess is variant 1, with 0 at the microswitch, that would make it more generic, would need to calculate one one offset when I replace the tool.

How have you done it? Or how would you do it and why.

Cheers, Chriss

[Chriss]

I have the feeling that I should use Z according to:
https://docs.duet3d.com/en/User_manual/Tuning/Defining_tool_and_Z_probe_offsets

[Chriss]

I use G10 L2 now to define the offsets from the HRP:

G10 L2 P0 X0 Y0 Z2

I tested a bit, the tip of the nozzle is ruffly 2mm deeper than the z-probe. I expected to see a jump of the z high when I select T0 than but nothing happens when I select T0. Z is still at 2mm when the nozzle barely touching the bed. Did I miss understand something?

Cheers, Chriss

[droftarts]

@Chriss I'm not that familiar with coordinate system usage (it's more of a CNC thing), but I don't think you should be using G10 P0 L2. This is setting coordinate system (L2) 0 (P0) to the XYZ offsets. However, coordinate systems are numbered 1 to 9, and the default coordinate system is 1. See https://docs.duet3d.com/User_manual/Reference/Gcodes#g10-set-workplace-coordinate-offset-or-tool-offset and https://docs.duet3d.com/User_manual/Reference/Gcodes#g54-select-coordinate-system

L2: this sets the origin of the coordinate system number specified by the P parameter (1 to 9) to the specified X, Y, Z... values

Initially, coordinate system 1 is in use, and all coordinate systems have zero offset from the machine coordinates.

L2 is usually used to set workpiece offsets in CNC machining operations.

This page https://docs.duet3d.com/User_manual/Tuning/Defining_tool_and_Z_probe_offsets doesn't say to use L2. Use L1, or no L parameter as L1 is the default, with the P parameter for the tool number.

Ian

[Chriss]

@droftarts Thanks for grounding me again. I may have misunderstood the docu of G10.

I may have overlooked that:

In your G10 tool offset setting commands (these G10 commands have axis letter parameters and a P parameter but no L parameter), specify the offsets of the nozzle or cutting head relative to the HRP.

I will drop the L parameter than and see how it behaves than.

Cheers, Chreers