Max Bed Temp
-
M143 can set Max Hotend Temp
but how to I set a Max Bed Temp? -
Currently there is no facility to set a bed temperature limit.
-
Is this something that will come in a future firmware release?
-
Is this something that will come in a future firmware release?
I'd like to second that, 125 degrees seems to be a bit restrictive. Was trying to print polycarbonate and while my bed could handle 140, there's just no way around it short of an external PID controller.
-
The temperature limits can be set independently for each heater in firmware version 1.17. See http://reprap.org/wiki/Gcodes#M143:_Maximum_hot-end_temperature.
-
Thanks a lot, works now!
