mainboard 6d not answering

[zecreton]

@Phaedrux the error i get is: the server where this page is located is not responding

[Phaedrux]

Are you able to ping the IP address of the Duet?

[zecreton]

@Phaedrux i don't know how to understand the results, but here
PING 192.168.1.14 (192.168.1.14): 56 data bytes
Request timeout for icmp_seq 0
Request timeout for icmp_seq 1
Request timeout for icmp_seq 2
Request timeout for icmp_seq 3

--- 192.168.1.14 ping statistics ---
5 packets transmitted, 0 packets received, 100.0% packet loss

[dc42]

@zecreton have you run M552 without parameters from the serial terminal, to check that Ethernet is connected and configured at that IP address (192.168.1.14) ? The response should be:

Ethernet is enabled, configured IP address: 192.168.1.14, actual IP address: 192.168.1.14

[zecreton]

@dc42 the mainboard doesn't answer to that command

[Phaedrux]

@zecreton said in mainboard 6d not answering:

192.168.1.14

How did you determine that was the IP address of the Duet?

[zecreton]

@Phaedrux my usb-c bugged, i unplugged and plugged again and now it works

[zecreton]

@Phaedrux Ethernet is enabled, configured IP address: 192.168.1.14, actual IP address: 192.168.1.14

[Phaedrux]

Is your computer on the same subnet as the Duet? 192.168.1

[zecreton]

@Phaedrux where do i see that?

[Phaedrux]

I don't have any information about your computer/os setup, but you should be able to find directions from a quick google to determine your internal IP address.

[zecreton]

@Phaedrux it is not the same

[zecreton]

@Phaedrux how do i change it?

[Phaedrux]

The computer must be connected to the same network as the Duet to be able to communicate with it.

[zecreton]

@Phaedrux i don't understand, i only have one network

[Phaedrux]

What is the IP address of your computer?

[zecreton]

@Phaedrux it is 10.0.0.14 i think

[Phaedrux]

If that is your internal IP address then your Duet isn't on the same network.

[zecreton]

@Phaedrux if i connect my pc and the mainboard with an ethernet wire it should be the same right?

[Phaedrux]

Yes, you can follow the directions here

https://docs.duet3d.com/en/User_manual/Machine_configuration/Networking#wired-direct-connection