"G28 Error: G0/G1: insufficient axes homed" after months of use

[Phaedrux]

Can you check your endstop state with M119 and post your full config? Also please send M98 P"config.g" for good measure and share the results?

[jay_s_uk]

@ignacmc post your config.g please

[ignacmc]

@phaedrux

[ignacmc]

@jay_s_uk config.g

Here you have it...sorry for the verbosity of my comments

[jay_s_uk]

@ignacmc nothing i can see if your config file.
can you post homedelta?

[ignacmc]

@jay_s_uk homedelta.g

[jay_s_uk]

@ignacmc nothing in there either that would cause issue

[ignacmc]

@jay_s_uk Yes, I have been printing with these config files for months without issues. I suspect some hardware problem. As I was going to replace my LDO 0.9 motors for OMC equivalents, I will do it and recheck all wiring at the same time...

[dc42]

@ignacmc here's the problem, in your homedelta.g file:

G1 X0.01 Y0.01 Z0.01

Either add H2 to that line, or replace it by:

M17 X Y Z ; enable motors for stealthChop tuning

M17 is implemented in RRF 3.3 and later.

[ignacmc]

@dc42 David....you are a father to me! It did the trick...

Stupid me, I forgot I have made that change a few days ago while researching here how to tune Stealthchop and didn't print since then so I was not aware of the problem I had just created.

Today in Spain is the Fairy Kings day, when tradionally Christmas presents arrived. This has been a very nice one!

Thanks for your outstanding support!

Ignacio