End Stops suddenly don't work (Solved, Faulty 6hc Board)

A Former User

This post is deleted!

Phaedrux

@arnold_r_clark said in End Stops suddenly don't work:

The problem with the end stop issue went away as soon as i moved the end stops to the main board (6HC) but not long after that (about 10 minutes) the main board started dropping connection to the DWC and re-connecting but then refused to connect to DWC unless USB was connected and if the USB connection was/is removed DWC connection stopped again. The tool board is powered from a direct fused PSU connection and not from an "out" connection on the main board

Ah ok, when you said this

@arnold_r_clark said in End Stops suddenly don't work:

I then took the tool board out of the loop and connected the end stops to the mainboard io1 & io4 this restored normal operation for a short time.

I took "for a short time" to mean that the endstops only worked correctly for a short time, but I see now you meant that the DWC problem started shortly after that.

@arnold_r_clark said in End Stops suddenly don't work:

but as soon as i disconnect the USB connection fails.

When you disconnect USB do the ethernet LEDs go off? Does the 5v or 3.3v LEDs on the board itself go off?

@arnold_r_clark said in End Stops suddenly don't work:

The tool board is powered from a direct fused PSU connection and not from an "out" connection on the main board

If you disconnect the toolboard entirely from the mainboard does the behaviour with DWC change?

A Former User

This post is deleted!

dc42

@arnold_r_clark this is on my list to look at tomorrow.

A Former User

This post is deleted!

A Former User

This post is deleted!

Phaedrux

Do you have anything else connected to the board at the moment?

Can you try disconnecting everything except VIN and ethernet to see if you can connect reliably again?

Another thing to check is whether any of the components in the 5V regulator area is getting hot, e.g. the AOZ1284 regulator chip, or any of the inductors close to the AOZ1284

How are you powering the 6HC? VIN only, or are also with separate 5v?

A Former User

This post is deleted!

dc42

@arnold_r_clark please start a new thread about your 6HC board no longer working without external power, as this is different from the title of this thread.

A Former User

This post is deleted!