What is the difference between the new G32 and G29?
-
Hello all,
I am curious what the actual difference between the G32 command and G29 command. I am running reprap firmware 3.0 on my Duet 2 Wifi.
Any advice on this subject would be greatly appreciated. Thanks
Jordan Stephenson, JD
-
G29 is used to do mesh bed compensation.
G32 is used to do the following:
- Auto calibration on delta printers
- True bed levelling on printers with multiple independent Z motors
- The manual bed levelling assistant on machines with manual bed levelling screws
- Old-style 3-, 4- and 5-point bed compensation, which is deprecated and likely to be removed soon.
-
https://duet3d.dozuki.com/Wiki/Gcode#Section_G29_Mesh_bed_probe
https://duet3d.dozuki.com/Wiki/Gcode#Section_G32_Probe_Z_and_calculate_Z_plane
https://duet3d.dozuki.com/Wiki/Using_mesh_bed_compensation
https://duet3d.dozuki.com/Wiki/Using_the_manual_bed_levelling_assistant
https://duet3d.dozuki.com/Wiki/Setting_up_automatic_probing_of_the_print_bed
https://duet3d.dozuki.com/Wiki/Bed_levelling_using_multiple_independent_Z_motors