Lines on part every couple of mm

Veti

VFA

see
https://github.com/MarlinFirmware/Marlin/issues/13529

to fix it use 16 tooth pulleys and 0.9 degree steppers.

Marcin1415 created this issue in MarlinFirmware/Marlin

closed Eliminate VFA's (Vertical Fine Artifacts) Huge quality improvment! #13529

dc42

What type of printer is it, and what are your axis steps/mm and axis motor microstepping?

Is the pitch of the vertical lines exactly 2mm? If yes, do you have any belts that go around non-toothed idlers? If no, what is the exact pitch?

rikesh942018

@dc42
Its a custom built machine, mostly made using machined aluminium plates and other metal components.

The Z is a 1204 Ballscrew.
It is hard to measure the lines but I would say they are about 2mm.
Axis steps/mm is: X80 Y80 Z800 E415 all with 256th Micro-stepping
Yes the belt does go around non-toothed idlers but only the back of the belt for X and Y axis and for the Z axis the Belt goes around both toothed and non-toothed idlers (back of the belt) and the pitch is 2mm.

deckingman

@rikesh942018 said in Lines on part every couple of mm:

Axis steps/mm is: X80 Y80 Z800 E415 all with 256th Micro-stepping

Do you really mean that? Those values are fairly typical of something with say 20 tooth pulleys and a Bondtech or Titan extruder using 16X micro-stepping rather than 256 X. Did you mean 16X with interpolation perhaps? Or have you set steps per mm @16X then changed to 256X using M350 afterwards (in which case the firmware will recalculate the steps per mm to something like 1280 for 256X for the X and Y axes).

rikesh942018

@deckingman

Yep sorry, I mean't 16X with interpolation

dc42

@rikesh942018 said in Lines on part every couple of mm:

@dc42
Its a custom built machine, mostly made using machined aluminium plates and other metal components.

The Z is a 1204 Ballscrew.

It is hard to measure the lines but I would say they are about 2mm.

Axis steps/mm is: X80 Y80 Z800 E415 all with 256th Micro-stepping

Yes the belt does go around non-toothed idlers but only the back of the belt for X and Y axis and for the Z axis the Belt goes around both toothed and non-toothed idlers (back of the belt) and the pitch is 2mm.

Vertical lines with exactly 2mm spacing, when you are using GT2 belts (2mm pitch) for the X and Y axes, are probably caused by belt teeth. If the lines were caused by inconsistent microstep size then I would expect the pitch to be a binary multiple of 0.2mm instead.

Phaedrux

Are you talking about horizontal or vertical lines?

rikesh942018

@phaedrux @dc42

Sorry for the confusion, I am referring to this horizontal lines that are visible.

dc42

OK, that's called "Z banding". Do a search for that on any of the popular 3D printing forums and you will get lots of hits. The first thing to check is whether the pitch of the banding matches the pitch of your Z leadscrew.

Veti

but the vertical lines clearly visible on the red cube are VFA