BLTouch isn´t working after change to Duex 5

[Computiger]

My BL Touch was working well till today as I´ve installed Duex 5 Board.
I used the Heater 3 Pin to drive the servo of BLTouch.

I have configured Heater 7 in Config.g
M307 H7 A-1 C-1 D-1
I didn´t touch the mode entry
M558 P9 H5 F100 T2000

If I send the Test Command the Heater LED is set on

Any suggestions?

[dc42]

Remove the I1 parameter from the M280 commands that you use to control the BLTouch in deployprobe.g and retractprobe.g, and anywhere else that you use them.

[Computiger]

Thanks David,

that was the reason.