Duet "Crashes" on Print
-
As an additional test I have also tried printing direct on the duet screen and that also does not start the print.
-
Just to be clear. You can home all the axes, heat the bed, heat the hot end and extrude filament yes?
-
@deckingman Yes, I have full control of the printer and everything works, I just can't start a print
-
@mark That's very odd. Does it do it with every gcode file or just one particular file? I wonder if your SD card has become corrupted. Have you tried a different card?
-
I have tried a new Benchy and a calibration cube that has been on the card a while and printed previously.
If I backup all the files on the card and do a factory reset and the issue still persists (once I do a manual setup again), can I just copy the backed up files back on the card to get back to where I am at the moment?
-
An easier test would be to use a new sd card. Copy the contents of your current card over and try the new card.
-
@Phaedrux
will try it out tonightThanks
-
@mark, your M122 report indicates that the last software reset was user-initiated, not a crash. This may have been caused by using the Emergency Stop button, or by sending M999, or by upgrading firmware.
-
I figured it out, and am very ashamed to say it was user error
I accidently uploaded the slt rather than G-code file!
@deckingman thanks for your input and keep up the good work on your projects, you have a new follower
@Phaedrux thanks for the advice
@dc42 Again thanks for responding - should uploading anything else other than a g-code file to print be a valid user story?Again thanks all for you inputs
Mark
-
How did you upload an STL? I've just tried and the file selector greys them all out and dragging and dropping won't take it either.
-
@Phaedrux I can still upload a stl. Maybe I am not using the latest firmware - I need to work out how to update it, but that's a job for another day!
-
Download this zip file https://github.com/dc42/RepRapFirmware/releases/download/2.03/Duet2Firmware-2.03.zip
Then upload the whole zip file as is to the Settings page in the DWC. That's all you have to do.
