Sanity Check Plz!!! Omron Inductive switch for XYZ endstops

[3DPMicro]

This is for a mill so no Z probing. I can get 3 of these dirt cheap https://www.ia.omron.com/product/item/1017/
and would like to use them on a new mill build. Here's my board info...

I see info here https://duet3d.dozuki.com/Wiki/Connecting_a_Z_probe#Section_Mode_Num_5
on how to connect as a Z probe but how do I hook them up for XYZ endstops?
Thanks

[Veti]

if you have a duet v1.04 you connect them like a npn probe
https://duet3d.dozuki.com/Wiki/Connecting_a_Z_probe#Section_NPN_output_normally_open_inductive_or_capacitive_sensor
but instead of connecting the signal wire to the z probe port you connect the signal wire to the stop pin for xyz

[3DPMicro]

Thanks for holding my hand on that one Veti. I have board v1.02 so I'll add in the diodes as well.

[3DPMicro]

Please confirm my wiring. My confidence is low

Sensor wires
Brown = 24 Vin on Duet
Blue = ground on Duet
Black sensor wire to Cathode(-) schottky bat43 diode, . Anode (+) side of bat43 to "stop" pin on endstop

M574 X2 Y2 Z2 S0
All stops are on the high end using NO switches

[dc42]

That looks OK to me.

[3DPMicro]

Thank you Sir.
Results are good. This switch repeats within .002 mm and that's probably in the mechanics. Perfect for milling application