Can access but cannot control....

peirof

Hi,

After 4 correct prints, today I connected the printer and I found the following problem:

The extruder has disappeared.
The bed does NOT detect the temperature
I've tried Homing, and the engines make noise but it DOES NOT move.
The WiFi, after restart, does NOT connect automatically, I have to restart it by DWC.
The same functionality that I have for the DWC, I have it for the DueFirmware Panel

It's a DUET 2 WiFi board

The firmwares that it carries in these moments, are, if I remember correctly, those that it took when it installs it.

Firmware Name: RepRapFirmware for Duet 2 WiFi / Ethernet
Firmware Electronics: Duet WiFi 1.02 or later
Firmware Version: 1.21 (2018-03-21)
WiFi Server Version: 1.21RC4 (08b3)
Web Interface Version: 1.21-RC4**

peirof

i have try to uptadte firmwares.... but the same

in this moments:

Firmware Name: RepRapFirmware for Duet 2 WiFi/Ethernet
Firmware Electronics: Duet WiFi 1.02 or later
Firmware Version: 2.0(RTOS) (2018-06-05b3)
WiFi Server Version: 1.21RC4(08b3)
Web Interface Version: 1.21.1

dc42

Check that you have the correct files in /sys on the SD card, and check that the config.g file looks ok in particular.

peirof

@dc42

again ... thanks DC42.

it was a typographical error in config.g .... it had that instead of M558, it had M559 ...

Solved, thanks