2.01beta1 baby step / z movement bug
-
First, it seems baby step is not carrying over between prints. If I have to lower nozzle height by 0.1 for a print, then print again, I have to lower it by another 0.1
Second, it seems the Z height will not move below 0 - $babystep.
For example babystep is at -0.7, G1 Z0 will bring it down to 0.7. running G1 Z0.5 will have no effect. -
Any ideas on this?
-
@nyt said in 2.01beta1 baby step / z movement bug:
Any ideas on this?
Only that the purpose of baby stepping is to correct first layer adhesion for a single print. If you have to use it every time, then you should make a more permanent fix for the incorrect first layer height, e.g the Z offset when homing.
-
This may also be related to a bug in beta1. I suggest trying beta 2 and seeing if it is resolved.
-
Yes, please try 2.02beta2.