M558 - questions in regards to A parameter

[Dougal1957]

David

The A Param is still not clear when it says maximum number of probes at what point does the Firmware stop probing early I assume it is once a certain number of probes are within the tolerance range but a bit more clarity may be in order here?

[dc42]

@dougal1957, see the new paragraph that I added at the end.

[Nxt-1]

@dc42 said in M558 - questions in regards to A parameter:

I have expanded the description of M558 on the GCodes wiki page. Let me know if it isn't clear.

This explanation helped me as well, thanks

[Phaedrux]

@dc42 Will P10 probe type for stall detection be added to the documentation? Or is it a little too experimental for broad distribution?

[dc42]

@phaedrux said in M558 - questions in regards to A parameter:

@dc42 Will P10 probe type for stall detection be added to the documentation? Or is it a little too experimental for broad distribution?

Good point, I will add it.

[T3P3Tony]

@dc42 I have added it here too:

https://duet3d.dozuki.com/Wiki/Connecting_a_Z_probe#Section_Mode_Num_10

[Phaedrux]

@t3p3tony would it be a good idea to link to the forum thread discussing implementation of z stall probing?

[T3P3Tony]

@phaedrux yes - which one is it?

[Phaedrux]

@t3p3tony I'd say this one

https://forum.duet3d.com/topic/4772/motor-stall-detection-as-z-probe

[T3P3Tony]

@phaedrux thanks, done.