Allow multiple connections from different devices
-
Apparently if more than one device (say my PC and my phone) connect to DWC, something in DWC gets confused and status messages and the results of commands are stale and/or not reported correctly. More details (and a workaround that I haven't tried yet) are in this thread: https://www.duet3d.com/forum/thread.php?id=3793
I hope this is an issue that can be addressed. I like to check on my prints' status wherever I am in the house, and would like to not have to fix DWC after every time that happens. Happy to do any testing/verification that will help.
-
I agree, this needs to be addressed. I'll put it on the list for the version 2.0 firmware.
-
I commonly use my phone and computer simultaneously to control my printer because of its location in relation to the computer and cannot every remember there being an issue.?
-
The issue usually only occurs if you turn one of the connected devices off without pressing the Disconnect button first.
-
The issue usually only occurs if you turn one of the connected devices off without pressing the Disconnect button first.
With phones this is rather common, they tend to sleep after a while not being used…
-
Quite so - and tablets too.