Power failure and DNS name
-
Hi David DC42 and all
Two question
on beta 1.20 8
This wiki for power failure is corret for this release ? I use new versions 1.20 FW configurator at 12v ( set on 10 at 11 default is right ? I nedd create the file or is write in FW ?
https://duet3d.com/wiki/Setting_up_to_resume_a_print_after_a_power_failure
Second question
Why on my web interface ( Chrome ) I not work nome dns it work on IP address not on name my Delta : M550 PTyppa
Server not recognize …
Duet ethernet FW 1.20 8 / web 1.93 last edge
Sorry my bad English -
1. The M911 command has changed in release 1.20. See https://duet3d.com/wiki/G-code#M911:_Configure_auto_save_on_loss_of_power for the new command.
2. Sorry, neither NetBios nor Mdns is implemented on the Duet Ethernet.
-
Thanks David for the quick reply
sorry David …. but the recovery file is written on the SD without my own to create the cone files in the exact version 1.9 or I have to create the files ... am I confused? For the Delta system at 12V in ATX what values tell me ..... I think only a small movement in Z can do -
You have to put the movement commands that you want to occur when the power fails in the M911 command. You also have to write the resurrect-prologue.g command, which will be called from the resurrect.g file. The resurrect.g file is created automatically.
However, you may not be able to get auto save on power fail working with 12V power.
-
-
In firmware 1.20 you can just send
M116M916. That will run resurrect.g. -
In firmware 1.20 you can just send M116. That will run resurrect.g.
Thanks David…. but M116: Wait ?
Sorry, I meant M916.