Hi David
HW Duet Wi-Fi
FW 2.0R2
DuetWiFiserver 1.21 and DuetWebControl 1.21.1RC4
.....
Gcode file 2.5 Mb upload is very slow ... error on upload ...
No deleting file after upload ( failed ) .... DWC response : ....file is open ...
Thanks Giorgio
TYPPA Albert Einstein
@TYPPA Albert Einstein
Latest posts made by TYPPA Albert Einstein
-
RE: Firmware 2.0RC2 released
-
RE: Corner LEDs not working
Ok thanks for response DC42,
It is boring to always see the LEDs ON, especially at night with long prints. There is no possibility to switch them on / off with a command. Thanks again -
RE: Corner LEDs not working
The 3 white corner led on / off is possible , or light ever time when printing ?
Thanks -
RE: Happy new year….!!!!!
Auguri di buon anno 2018!!!
HAPPY NEW YEAR 2018 -
RE: Power failure and DNS name
In firmware 1.20 you can just send M116. That will run resurrect.g.
Thanks David…. but M116: Wait ?
Sorry, I meant M916.
-
RE: Power failure and DNS name
Hi David DC42
stupid question : on DWC 1.9.3 for printing file resurrect.g ? No option for printing …..use macro ?
FW 1.20 Beta 11 / DWC 1.93 / Ethernet
is problem on DWC/ Christian ?Ciao
-
RE: Motor Current
Mine is the same - looks like a glitch in the machine properties tab of DWC. Never looked at it before so it might have been there for ever. M906 with no parameters is the reliable indicator - ignore the values shown in the machine properties tab of DWC. I guess this is one for Chris Ham, not David.
Ok Thanks for the moment ….But on 1.9 FW is perfect on DWC...i reed 1200 mA
-
Motor Current
Hi David Dc42
Why on DWC the value Motor Current is 0 mA …is bug ?
My Config on 1.9.3 /1.20 beta 10 Duet Ethernet
M906 X1200 Y1200 Z1200 E1500 I30 ; Set motor currents (mA) and motor idle factor in per cent
Thanks -
RE: Power failure and DNS name
Thanks David for the quick reply
sorry David …. but the recovery file is written on the SD without my own to create the cone files in the exact version 1.9 or I have to create the files ... am I confused? For the Delta system at 12V in ATX what values tell me ..... I think only a small movement in Z can do