Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

Duet 1LC STEP file not matching v1.3

General Discussion

3

5

310

Log in to reply

undefined

MartinNYHC
last edited by

The step file for 1LC version 1.3 doesn't match.

https://github.com/Duet3D/Duet3-Toolboard-1LC/blob/master/Toolboard_1LC_v1.3/Duet3_TB_1LC_v1.3_STEP.zip
undefined undefined 2 Replies Last reply
Reply Quote 0
undefined

dc42 administrators @MartinNYHC
last edited by

@martinnyhc in what way doesn't it match the board?
Duet WiFi hardware designer and firmware engineer
Please do not ask me for Duet support via PM or email, use the forum
http://www.escher3d.com, https://miscsolutions.wordpress.com
1 Reply Last reply
Reply Quote 0
undefined

droftarts administrators @MartinNYHC
last edited by

@martinnyhc looks like the 1.3 layout to me. Here's the dimension drawing:

Ian
TronXY X5S with Duet 3 MB6HC and Roto toolboard : Cartesian bed-slinger with Duet 3 Mini 5+ WiFi and 1LC : RRP Fisher Delta v1 with Duet 2 Maestro : Polargraph with Duet 2 WiFi
undefined 1 Reply Last reply
Reply Quote 0
undefined

MartinNYHC @droftarts
last edited by
1 Reply Last reply
Reply Quote 0
undefined

droftarts administrators
last edited by

@martinnyhc you have a v1.2 toolboard there. Says on the PCB, top right of your photo.

Ian
TronXY X5S with Duet 3 MB6HC and Roto toolboard : Cartesian bed-slinger with Duet 3 Mini 5+ WiFi and 1LC : RRP Fisher Delta v1 with Duet 2 Maestro : Polargraph with Duet 2 WiFi
1 Reply Last reply
Reply Quote 1

1 / 1