Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

5v for Revo Micro fan

Solved

Duet Hardware and wiring

2

3

169

Log in to reply

undefined

Rushmere3D
last edited by Rushmere3D

Hi,

Can someone confirm it would be ok to use the 5v pin from an I/O connector on a 3HC to power the 5v hotend fan from an E3D Revo Micro.

Fan specs:
Follow my adventures in 3D Printing, laser cutting and electronics. https://linktr.ee/Rushmere3D
undefined 1 Reply Last reply
Reply Quote 0
undefined Rushmere3D marked this topic as a question
undefined

dc42 administrators @Rushmere3D
last edited by dc42

@rushmere3d yes that should be OK on the 3HC. We don't advise powering a 5V fan from the 5V supply on the TOOL1LC.
Duet WiFi hardware designer and firmware engineer
Please do not ask me for Duet support via PM or email, use the forum
http://www.escher3d.com, https://miscsolutions.wordpress.com
undefined 1 Reply Last reply
Reply Quote 1
undefined

Rushmere3D @dc42
last edited by

@dc42 Thanks for the swift response.
Follow my adventures in 3D Printing, laser cutting and electronics. https://linktr.ee/Rushmere3D
1 Reply Last reply
Reply Quote 0
undefined Rushmere3D has marked this topic as solved

1 / 1