Dotstar questions?
-
@TKWARD said in Dotstar questions?:
@dc42 Thanks David.
Would the firmware changes be added just for this project ? Or, does it need to be added to the features 'wishlist' for Duet 2 firmware ?
if you do ahead with this then I will enable DotStar support in RRF3. It will need a new configuration command (probably a variant of M150) to specify which CS line to use.
How would this be operated in terms of G code ? with M150 command ?
Yes.
Also, assume that if a thermocouple board is used, only 2 of the CS would be available anyway ?
Yes. So you might want to omit the jumper block and just wire it to use CS1. If you stack it on top of a daughter board then it would use CS3 instead automatically, because CS3 feeding into the daughter board is routed to the corresponding pin for CS1 on the top connector.
-
I'm going ahead with it.
Jumpers removed.
CS is set to CS_1.
Tank Capacitor value changed, and resistors added as per your suggestion.Just waiting on an assembly price from Chinese supplier.
I'd like to send you a few boards to test with the firmware. ( Take this offline and get address etc via pm ?? )
Thanks
Keith -
Any updates on the project so far? I'd be interested in the schematics for the board
-
Is it possible to skip some LEDs in the settings?
Lets say LEDs 1-10 are set to different colors.
I want to change LED2 without changing LED1. -
@cando415 no, just send the same setting again for the LEDS who do not change.
-
can you store that info somewere? which LED should get what state?
-
@cando415 said in Dotstar questions?:
can you store that info somewere? which LED should get what state?
Possibly as a variable
-
@phaedrux
Oh! I have to upgrade my knolagebase!
That makes it much better.
Thx -
@phaedrux
is there a good tutorial for the metacommands somewere? -
I'm not aware of a tutorial, but between the wiki page and the meta command forum section you can find some examples and ask questions.
