Short-to-ground reported by driver 1 2

[dc42]

@gabinnan said in Short-to-ground reported by driver 1 2:

@jay_s_uk still it says the same. My wiring with nema17 :

• Red to 2B
• Blue to 2A
• Green to 1A
• Black to 1B

what is wrong?

Do the wires come directly out of the stepper motor, or is it a separate cable that plugs into the motor? If it's a separate cable then you can't trust the colours.

[gabinnan]

@jay_s_uk it think my wiring is right. I am using Nema 17HS16-2004S1.

It says the same error even the is no motor connected

[gabinnan]

@dc42 they are separated cables

[jay_s_uk]

@gabinnan can you post a photo of the end that goes into the motor?
Looking at the stepperonline page, they should be cables that come directly out of the motor, not with a separate plug.

[gabinnan]

@jay_s_uk

[jay_s_uk]

@gabinnan can you therefore confirm the stepper phases using a multimeter, ignoring the colours of the wires. The link I gave you should guide you in that.

[gabinnan]

@jay_s_uk

red & blue same phase
black & green same phase

[gabinnan]

@jay_s_uk solution?

[jay_s_uk]

@gabinnan try a different driver and see if the error follows it.
if not, when was your duet purchased?

[gabinnan]

@jay_s_uk it is not working. it was purchase on june 14th 2021

[jay_s_uk]

@dc42 or @Phaedrux

[jay_s_uk]

@gabinnan also, where did you purchase it from?

[gabinnan]

@jay_s_uk filafarm in germany

[Phaedrux]

@gabinnan said in Short-to-ground reported by driver 1 2:

It says the same error even the is no motor connected

It would seem likely that you have 2 failed drivers.

Please send an email to warranty@duet3d.com and CC your reseller. Include a link to this forum thread and the details of your original purchase. You'll receive a reply with a form to fill out.

Sorry for the inconvenience.