3D GCode Viewer integrated with DWC

[HebigT]

What might cause the cursor to be offset from the rendered preview?

I'm using a Toolchanger, so each of the tools have offsets with respect to the Z-probe. Perhaps the offset is not being referenced?

[Sindarius]

I’ll need to look i believe the code currently uses the machine position and not the tool position which could be the issue.

[MartinNYHC]

@t3p3tony said in 3D GCode Viewer integrated with DWC:

;PRINTING

[...]
G1 F3600 X138.747 Y111.877 E0.7349
;PRINTING: 3mm_hinge_a_with_logo_x2(1).stl
;PRINTING_ID: 1
G1 F1500 E-2.0000
[...]

but "show object selection" is disabled:

I'm using Ideamaker 4.1.1.5050 and RRF 3.3-RC2.

[chrishamm]

@martinnyhc If you are using RRF 3.3-RC2 in SBC mode, please try to delete /opt/dsf/conf/config.json once and restart the Pi. I forgot to update the default DCS config in RC2 which contains a change for object detection for IdeaMaker. By deleting that file DCS will use the new defaults automatically.

[MartinNYHC]

This post is deleted!

[MartinNYHC]

@chrishamm said in 3D GCode Viewer integrated with DWC:

@martinnyhc If you are using RRF 3.3-RC2 in SBC mode, please try to delete /opt/dsf/conf/config.json once and restart the Pi. I forgot to update the default DCS config in RC2 which contains a change for object detection for IdeaMaker. By deleting that file DCS will use the new defaults automatically.

Still not working.

[chrishamm]

@martinnyhc AFAIR parts of the second object have to be printed before the object selection starts working. If it still doesn't work, make sure you are on DSF 3.3-RC2 and that "PRINTING" is part of the FirmwareComments field in /opt/dsf/conf/config.json. That file should have been regenerated after the reboot.

[MartinNYHC]

@chrishamm OK, will try. Thanks.

[MartinNYHC]

After deleting /opt/dsf/conf/config.json it works Thanks!

[HebigT]

This post is deleted!

[HebigT]

@sindarius said in 3D GCode Viewer integrated with DWC:

I’ll need to look i believe the code currently uses the machine position and not the tool position which could be the issue.

@sindarius Did you have a chance to look into this?

I was working on someone else's E3D tool-changer today and experienced the same thing, so I wanted to check in.

DWC & Firmware Version: 3.3