pres. adv, or non lin. extrusion - what to calibrate first?
-
Hi what are your experience with calibration pressure advance and non linear extrusion? I first calibrated pressure advance and after a while I calibrated non linear extrusion, but then I had regions with underextrusion. So I disabled pressure advance and left the non linear extrusion paramters as they were before and the print results are much better and very good in my opinion.
What do you recommend? Should I also recalibrate pressure advance or isn't it nessesary when the non linear extrusion is calibrate correct?
Best Regards
Cai -
How did you calibrate them?
-
for pressure advance https://forum.duet3d.com/topic/6698/pressure-advance-calibration
for non linear extrusion https://forum.duet3d.com/topic/5588/non-linear-extrusion/22
-
is there a preference order?
-
It shouldn't make much different which order you calibrate them in, but if you intend to use nonlinear extrusion then I suggest you calibrate that one first.
-
Hello. Sorry for this question: Im looking for information about non linear extrusion calibration. I have found 2 different spreadsheets that seems to be used for calculation of the parameters to be used.
But I haven't found a procedure to do this calibration nor what is the correct spreadsheet to use. I have references about moving the carriage while calibrating, but it is not clear to me how should the measurements be done, what kind of printing moves do, etc.
Can someone please clarify this calibration to me?
Thanks in advance -
