I can't print object sliced with Prusa Slicer...

[A Former User]

It can't print every GCODE, it looks like the Extruder stepper spins with a low low low step/mm number....this is just a little example because only small files can be attached here....linked there are the extruder settings as well example.gcode

[matt3o]

@the_dragonlord have you tried disabling pressure advance?

[dc42]

@the_dragonlord, are you sure you have configured PrusaSlicer for the correct filament diameter, i.e. 1.75mm (assuming that is what you are using) and not 2.85mm?

[matt3o]

also if you are using prusa's presets be sure to remove any printer specific config in the filament gcode

[A Former User]

@matt3o yes

[A Former User]

@dc42 said in I can't print object sliced with Prusa Slicer...:

@the_dragonlord, are you sure you have configured PrusaSlicer for the correct filament diameter, i.e. 1.75mm (assuming that is what you are using) and not 2.85mm?

yes, it is 1,75

[A Former User]

@matt3o said in I can't print object sliced with Prusa Slicer...:

also if you are using prusa's presets be sure to remove any printer specific config in the filament gcode

No specific config are present

[matt3o]

@the_dragonlord I use absolute extrusion with Prusa, if that makes any difference

[A Former User]

@matt3o said in I can't print object sliced with Prusa Slicer...:

@the_dragonlord I use absolute extrusion with Prusa, if that makes any difference

I've tried both but none of them works.....

[engikeneer]

@the_dragonlord have you set a max volumetric flow rate (in printer or filament settings)?

What is your first layer speed set to?