i think fan0 mosfed died.

weput

@bearer fan1 works...

fan2 doesnt. ;(

by the way i'm already going to solder on a self tripping fuse when i can get one (stupid covid lockdown)

what would be the recommended replacement part for TR5?

A Former User

https://duet3d.dozuki.com/Wiki/Connector_and_spare_part_numbers#Section_Fan_mosfet

dc42

@weput, that looks repairable to me. If you can desolder the last remaining bit of the old mosfet attache to the top left pad, then it looks like it should be possible to fit a new one. https://duet3d.dozuki.com/Wiki/Connector_and_spare_part_numbers#Section_Fan_mosfet

A Former User

@weput said in i think fan0 mosfed died.:

fan2 doesnt. ;(

did the circled area clean up on TR1? if not it might need replacing as well. given fan 1 works, you might get away with new fets.

dc42

PS - I just found that old thread, https://forum.duet3d.com/post/34904. Relevant if your Duet doesn't have any blade fuses.

EDIT: but if fan 1 works, that trace must be OK.

weput

@dc42 ok dumb question:

how do i know if my duet has blade fuses?

A Former User

if you can't see them, they're probably not there

dc42

Check the PCB version marked on it. Version 1.03 was the first version with a fan fuse.

weput

@bearer this one definitely don't have.

A Former User

@weput the fuse is likely less important as long as Fan 1 works. But do take a closer look at TR1 after the clean up as indicated above.

weput

@bearer said in i think fan0 mosfed died.:

it look fine.... but fan2 still doesn't move.

A Former User

@weput said in i think fan0 mosfed died.:

it look fine

i'd beg to differ, looks like a tiny hole in it, and given the other symptoms odds are it has failed, just less spectacularly.

weput

well...

maybe is time to think on a newer duet?

fan1 had the heatsink fan on.. thermostatically controlled. Maybe that's why i didnt blew.

fan2 had nothing on it.

dc42

Please clarify: does just fan 1 work, or do no fans work (which is what you said in your original post)?

weput

@dc42 said in i think fan0 mosfed died.:

does

FAN1 works. (currently set as tool 0 fan.)
FAN2 doesn't.
FAN0 is blown.

weput

i just realized i wrote mosfed instead of mosfet.

(facepalm)

dc42

OK, so you have 2 failed mosfets.

weput

FYI guys...

i managed to make fan2 work.. but somehow fan0 aint doing it...

also, when i was about to solder the self resetting fuse (vssa), after removing the soldered wire for the temporary pot... i checked continuity and it had continuity... so the old fuse was working.

yeah... very strange.

A Former User

@weput said in i think fan0 mosfed died.:

so the old fuse was working

i think i've seen dc42 suggest waitng a day or two to see if the self resetting fuse recovers - but i though you had trouble with the fans, not the VSSA fuse that is for the thermistor ground connection?

weput

trouble with both.

i received the package (finally) with the spare parts.