Print Frozen - RRF3.01-RC12 and DSF 2.2.0
-
If you need more scripts or confits to troubleshoot this issue my entire configuration is available here https://github.com/mwwhited/MyMashedDuet/tree/master/duet3/dsf/sd
-
BTW, I don’t know why but when running the debug console I can still access the webpage and ssh but crontab stopped running.
-
@mwwhited, I believe this is fixed in the new firmware binary at https://www.dropbox.com/sh/3azy1njy3ayjsbp/AACquxr2m00eV568RZg5QG5wa?dl=0. Please can you test it.
-
@jay_s_uk The fix will most likely resolve your problem, too. Please give it a try if you can.
-
Great stuff. I'll give it a go
-
@dc42 How long should this update take to apply?
it's been saying "Please wait while updates are being installed... " for over 15 minutes.
-
I'm now getting "Timeout while waiting for transfer ready pin" when I try to start DuetControlServer in debug mode.
-
I got that when I installed both the expansion and main board updates. It started working again once I fully powered off the machine
-
It should be very quick, like any other firmware update. I suggest you try updating the firmware using Bossa instead.
-
Okay, I'm back up and running after wedging a USB cable into my controller (guess I should have left some more room to work with.) I'll let it run and let you know how it goes.
-
I've updated the firmware on my boards but not had chance to run a print yet. Too busy tweaking my tpre and tpost files.
-
I haven't seen any more issues today... but I'll continue to keep and eye on it.
-Thanks,
Matt -
Didn't fix the issue. I was working on my toolhead scripts this morning and RPi froze.
-
@mwwhited Please try out the latest software bundle, there have been some more improvements since then. If you do see more freezes, please check the log of DCS (
sudo journalctl -u duetcontrolserver -e
).