Job status by filament usage
-
-
@gnydick said in Job status by filament usage:
@dc42 sorry I've been away, @dc42 . The prusa slicer bug is what I'm referring to. The DWC shows nothing for filament usage.
When was that fixed?
Did you read what dc42 has written? Please post a sample g-code file with this problem and config.g. And maybe M122 response because I use Prusa Slicer too and don't have any problems with filament usage.
-
@gnydick said in Job status by filament usage:
@dc42 sorry I've been away, @dc42 . The prusa slicer bug is what I'm referring to. The DWC shows nothing for filament usage.
When was that fixed?
There is an entry for Prusa slicer in the version 2.03 section of the whatsnew file. Is that the one you mean?
-
Prusa slicer just starting to print skirt of model...…….
-
In Cura, all jobs have max layer of 25...…….
-
Firmware version?
-
Its a Duet Ethernet on version 2.02RTOS. Luckily I have a camera so I can guestimate myself.
-
@chas2706 said in Job status by filament usage:
Its a Duet Ethernet on version 2.02RTOS. Luckily I have a camera so I can guestimate myself.
Please try 2.04RC4.
-
Ok thanks I will try it out later and let you know.
-
"Recognise filament usage comment in Prusa slicer" was added in RRF 2.03.
If you're going to update, don't forget to check through the What's New document to see how changes to the firmware may effect your configuration. And back up your existing, working config, so you can revert to it if necessary.
Ian
-
Ok will do, thanks for that.
-
Just Updated to 2.04RC4 and everything looks good.
Many thanks. -
@chas2706 said in Job status by filament usage:
Just Updated to 2.04RC4 and everything looks good.
Many thanks.Thanks for the confirmation!
