@dc42:
I have heard that Nema 23 motors vibrate much more than Nema 17. Have you tried the same motor on the Duet 0.8.5?
Yep, this is the machine that started life with the 0.8.5 board.
I do not recall noticing this issue with that board however i also wasn't printing a slow as I am atm as i sort out print speeds with the 0.6mm nozzle.
It would seem that the speed combinations are crossing over the mid band resonance of the nema23's.
One poitn though is I may not have noticed it with the old board due to the greater noise in general….. the DuetWifi is just so quiet.
@dc42:
To turn off microstep interpolation use the M350 command, see http://reprap.org/wiki/G-code#M350:_Set_microstepping_mode. You can try increasing microstepping to x32, x64 or greater as well.
Thanks for that, i'll try a few of those tomorrow after this print finishes.
Cheers and Thanks Dave