@gloomyandy Sorry for the late reply. You know how it is when you get involved with printers... time just seems to disappear.
Updating the firmware resolved the issue. Thank you.
@gloomyandy Sorry for the late reply. You know how it is when you get involved with printers... time just seems to disappear.
Updating the firmware resolved the issue. Thank you.
@tmitch205 Disregard this one. I went diving into code for the prints. It's the slicer causing it. As an example, in the most recent one, for some reason, my layer height is set to .20, but the code has the skirt/brim at .32.
@phaedrux I was going to ask the same thing about static considering it's sitting on carpet. I have seen Duet 2 Wifi's lose their wifi connectivity due to this until they are restarted.
@jay_s_uk I have a crap ton of the front, but none of the back. It will be a bit before I can get a pic of rear.
If you are going to use an external 5V supply to the board, you must remove that jumper labeled INT 5V EN. You will wire the external 5V supply to the board using the EXT 5V IN pins found just to the left of the VIN Power In. Is this the 0.1 or 1.0 board?
As to why those pins for the other two options are missing, I have no clue. I use the 6HC, and those same 2 sets of pins on mine were never installed either.