6HC + 1LC. Input shaper No accelerometer found!

[tmitch205]

I forgot to mention that the 1LC is version 1.2

[jay_s_uk]

@tmitch205 I take it you have M955 in your config?

[tmitch205]

@jay_s_uk Correct

M955 P121.0 I10

[jay_s_uk]

@tmitch205 are you able to get a photo of the back of the toolboard?

[tmitch205]

@jay_s_uk I have a crap ton of the front, but none of the back. It will be a bit before I can get a pic of rear.

[gloomyandy]

@tmitch205 What happens if you enter the M955 P121.0 I10 into the console?

[tmitch205]

@gloomyandy It sends a successful message in the console. I will get the exact wording in about 30 minutes.

[gloomyandy]

@tmitch205 I think you should upgrade the 1LC firmware to match the 6HC and try again....

[tmitch205]

@gloomyandy I will do that and report back. Thank you for the suggestion.

[tmitch205]

@gloomyandy Sorry for the late reply. You know how it is when you get involved with printers... time just seems to disappear.

Updating the firmware resolved the issue. Thank you.