@stuartsm said in Thanks for a fantastic controller design.:
Several months ago, I bought a Duet Wifi and 7" PanelDue. Its been slow progress, designing and printing (and redesigning) (rinse and repeat until satisfied) a case for it.
To add to the delay, I also migrated my Creality CR10 to an E3dV6 with direct Titan Extruder.
Today I finished the cables between the controller and the printer.
It is printing its first print as I type.
I am so impressed with the ease of configuring the printer and so thankful for this forum which has helped me over little hurdles.
Now I just have to get my BLtouch connected and my laser filament sensor running and it will be complete.
Without this forum, I would never have considered replacing the controller.
Many thanks for the work put into the firmware and the helpful responses in the forum.
I've not yet had to post as the answers I required were always already there.
I'm sure i will though at some point.
Again, thanks for making this process as painless as it was.
Stuart Smith
Thanks for the feedback! Having satisfied customers gives me a warm feeling.