Topics created by SoDamnInsane

@droftarts Thank you! FAN0 and FAN2 don't work. I ordered a few MOSFETS. The newer ones, that are installed at the Duet3 mainboard. I hope i have them tomorrow, otherwise it will be de day after tomorrow. I'll post the results here. 🤞

@Phaedrux Sorry, for my late reply! I was very busy the past 2 days. I found a old config file. I'm using the same settings. Now i have another problem with the Fans. But i will post a new question for this.

@jay_s_uk Ohhhh ok! Thank you very much. Due several circumstances i couldn't do anything with 3D Printers for 6 years. But i realized that I've forgotten a lot, to be honest. And now I'm so insecure and doubtful about everything. Thank you! 👍 😉

@Phaedrux said in Mesh Compensation settings disappear.:

Using always on for the hotend is fine.

If you select tool fan does the slider work to control the tool fan?

Are you sure you have the part cooling fan plugged into the Fan0 port?

I can move the slider(s), but the fan doesn't start.
B.t.w., if I use the FAN1 pins, it works.
Isn't that strange?

Thx for the link of the DWC 2.1.1 update, @droftarts

The Extrusion Control is now working.

I also did the same, documented the process: https://forum.duet3d.com/topic/14485/rrf3-bltouch-setup?_=1583394715553
I'm now using a duex5 though so no longer use that setup.

@SoDamnInsane … and I had to print new part-cooling ducts without having part cooling available to print them - that was a major design challenge 😱

Thanks @Phaedrux and @droftarts !! You made me very, very happy!!! It's working now! 👍 👍