Best posts made by sneakyferret

Thanks everyone who actively helps out on the forum. I couldn't have done it without you and the patient support of those here. My printer is a HE3D K280 running on a Duet2 wifi board and Smart effector v4. I made a twitch stream to watch long prints from anywhere so if you want to watch it go, head to www.twitch.tv/synthsnprints .

I make no money from this stream and it's purely for fun so hop in, give some recommendations, chat, and visit while listing to relaxing music.
Thanks again everyone!

@Nxt-1 Thats comforting. That is about the length my wiring is from board/supply to effector. Right now I am just dealing with a strange height map that I cannot diagnose after literally tearing apart my printer and reseating every bolt but thats for another post. I cannot state enough how much I appreciate you guys helping everyone out here. Thank you!

@claustro not sure if applicable but a YouTuber was having the exact same problem with a different printing software and found that it was the resume after power loss feature causing the issue. Maybe give this a look? Video here about their problem

@OwenD Knew it was something dumb. Much appreciated!

@sneakyferret Now to fight the never ending fight of drum roll bed level mesh compensation! Love you guys.

@sneakyferret One thing I have recently noticed: When doing a mesh calibration run, some coords the smart effector makes a very audible but normal 'tap' sound as it contacts. Other spots, its either very muffled (like its tapping cloth) or not audible at all. THE PLOT THICKENS.

@o_lampe Interesting development. I did what you said and identified a single rod that was more loose than all the others. I swapped them around, no difference. Turns out, its that rod position that is more loose no matter which rod is in that place.