Topics created by sinole

@gloomyandy I put it there ill add it here too maybe it helps someone some day
m122.txt
m955 p0
Accelerometer 0 type LIS3DH with orientation 41 samples at 1344Hz with 10-bit resolution, SPI frequency 1000000

@jay_s_uk said in power loss with UPS:

@deckingman I run M669 S1 T1 on my CNC no issue

Good to know - thanks.

@phaedrux well damn i see what is happening there are pre saved values in config-override.g, it is doing what it should overriding my config. 🙂

@nightowl999 well looks like if you have a ups module you can manage the power recovery very well even without M911. in trigger file you can pause the printer or cnc with G25 and it makes sys/resurrect.g
after that you can just recover with m916. I will write guide if it works, I think you can use it. those ups are very cheap.

@dc42 I have seen a stl that supposed to show ringing. seemed very long process. which method is more effective in your opinion?

@oliof Basically any internally temperature compensated probe will do (with proper output type obviously). I did some research once and Prusa's was cheapest one that works with 5V power supply (original prusa board back then, not required for duet) and is temp. compensated and in 8mm diameter).

@sinole said in using 12v fan in 24v setup.:

everything other than noctua screams at you

D'accord. I think, your noctuas deserve a distinct 12V PSU - that's a clean solution, and they are worth it. Good luck! 👍