Topics created by Sevimuelli

@chrishamm Ok i figured out the problem. When i have the folder with all the required files in it, like dsf, sd and plugin.json for example, I need to compress the files inside the folder directly and not the folder itself. Don't know, it looks the same when you decompress it and everything but i guess there's a difference. Hope that makes sense. Anyway, thanks for your help. You can close this topic now.

@Sevimuelli As I said I don't think leaving it in relative mode is likely to be the cause of this issue, however, having your printer in a different state after a print to after homing does not seem like a good idea.

I wasn't suggesting that you should hide the axis, I was asking if there is any chance that the axis has become hidden and that might be causing the homing problem.

Again I was suggesting that you check the state of the endstop (just in case there is some firmware, electrical or mechanical problem with it - it may have become stuck) as that would result in the behaviour you are seeing.

@dc42 @Sevimuelli Done.