Best posts made by Sculpt Fabricator

Found the problem, the Modix crash detector is a magnetic sensor and when
triggered it sends the same Emergency Stop that we were getting mid print. Even the one 20 min into the print. My guess is a faulty crash sensor, running
like normal now that it is temp. bypassed.

We currently have a self contained high voltage bed heater that uses a TCN4 that controls and displays bed temperature and does not connect to our duet wifi board. We had originally drilled a thermistor into the side of the bed and hooked to the Bed Temp input on the duet wifi board to be able to get some visual on the computer that the bed was on and working, but the temperature is not close to being correct.
The TCN4 uses a PT100 to read the bed temperature. We hoped we could connect to this at the TCN4 input and hook to the Bed Temp input of the duet wifi board and get an accurate reading, but we are getting around 540C reading when off and the ambient is around 23C
After some research I see that the PT100 needs an adapter board like we have on our two extruder PT100's but not sure how one would plug into the Bed Temp location, if this is even the issue, or maybe just a setting, any help would be much appreciated.

We are running Duet WiFi 1.02 or later + DueX5 version 2.05 (2019-12-13b1)

M305 P0 T100000 ; Set thermistor + ADC parameters for bed heat

Sorry, I tried to upload some pictures of what we had but keep getting an error !

@phaedrux we actually followed the
Fallback procedure #1 and got it back up and running again, thank you for your help

@droftarts
The SD card was really full we deleted everything out of it. I will look into
that more