@gloomyandy Yes I'm indeed in SBC mode

@gloomyandy I had 3.3.x installed before and I tried to update to 3.4.6. I followed this guide: https://docs.duet3d.com/User_manual/RepRapFirmware/Updating_firmware

So I basically downloaded the zip and uploaded it to dwc and I just let it do its thing.

I tried to update the firmware on my toolchanger, but after 45 minutes it still wasn't ready. So when I restarted the printer I couldn't reconnect anymore.

• I think it can connect to the wifi, as it knows to tell me DCS isn't started.
• I can connect to the 6HC via pronterface, after sending M115 I can confirm that I am on the updated firmware.
• I have a touchscreen connected to the pi so I can get into the pi's console.

right before it tells me it failed to start DCS it tells me this: "duetcontrolserver.service: Failed with result 'protocol'."

Duet setup:

• 6HC
• Pi 4 - 8gb
• 3HC
• 2x 1LC

Any help would be appreciated

@dc42 Yeah I did also find that, but no KiCad project like the 6HC has for example...

Hello,

I would like to know if the files for the 1LC toolboards are available somewhere. I am specifically looking for the KiCad files for it. I can find the ones for the 6HC for example, but not for the 1LC toolboards.
Thanks!

@dc42 are there serial numbers on the toolboards? I have to fill them in in the form...

@dc42 Thanks for the quick response to my message, I'll send an email to that adress.

@dc42 I have only one toolboard connected now, I tried the factory reset. But no activity yet. The ACT and STATUS led don't light up. I tried for both boards, and I did put the jumpers back on the distribution board when disconnecting a toolboard.

@dc42 I live in Belgium, the boards were purchased recently at E3D Online.

@jay_s_uk yes I did , and still there is no sign of life in the boards. So no communication yet. But it really is a problem in the toolboards, because everything else works perfectly. And I have a spare V1.1 board brand new, I tried that and that works perfectly