We will be patiently waiting for your fork with all of the fixes, Sunshine
Best posts made by pogo1213
-
RE: Dave's so proud
-
Start Gcode for the Piezo Orion
Hey,
Just want some input, how have you adjusted you start gcode for the probe. What temps are your probing at and how have you adjusted your start gcode to accommodateThanks
-
RE: 2 fans showing, only one should
Setting>User Interface
There is a fan setting letting you choose which you would like visible. Select which you would like then select "Apply Setting".
Latest posts made by pogo1213
-
RE: Setting up Scanning Probe, possible dead SZP board
@oliof I can provide config shortly but shouldnt affect the initial connection of CAN (especially if other can devices are connecting just fine) and M122 of the board shows time out/ no connection.
-
RE: Setting up Scanning Probe, possible dead SZP board
@dc42 The red status light is blinking rapidly like it hasnt synced with the CAN.
Also yes there 5v supplied, I04 5v and ground are being used.
-
RE: Setting up Scanning Probe, possible dead SZP board
@droftarts It is the last board and is terminated.
-
Setting up Scanning Probe, possible dead SZP board
Hardware Used
Duet3 Mini 5+
2 1HCL boardsAll working properly
Added the Scanning Probe and cant get it to connect to can.
trouble Shooting already done
-Set the delay in the config as directed
-Added the code for the probe from the docs
-Checked that everything is updated to 3.5.1
-Plugged the SZP board directly into the Duet 3 rather than off the second 1HCL board
-Hit the reset button on the board
-checked continuity from the plug at the Duet3 all the way to the pads on the back of the SZP High and Low both good
-Checked it with and without the coil connected.At this point I believe I have a defective board. does anyone have any ideas on what else I could try?
-
Splicing a scanning tool board into CAN properly
Currently trying to set up the Duet Scanning Probe into my system. I'm currently running a Duet 3 IDEX system with full size tool boards (as in not the roto). I have the probe and Z Scanning board but since there is not can out on the tool board I want to make sure I splice into the CAN correctly. Im running the twisted pairs from the tool distribution board to the tool board that come with the newer distribution boards.
Is there a suggested way to splice it in. I just want to make sure I don't cause additional issues when doing this.
-
Does anyone use the PS_on port on the Duet 3
I have been looking into controlling when one of my power supplies is on since it has a fan that is away on and can get annoying.
This is the power supply I want to power down and I also have a 5v power supply just for the raspberry that is fanless and can stay on.
https://www.meanwell.com/productPdf.aspx?i=469At this point, I'm just looking for some insight into how someone is using it so I don't screw something up.
Cheers,
-
RE: Nozzle crashes before print starts.
Nope that looks good. Can you post your full config?
-
RE: Dave's so proud
Not sure if you are aware but there are thousands of different printer setups that have to designed around. You can't expect everything to be plug and play, if that is what you want buy a prebuilt unit and never modify it. Spamming is not the answer, best of luck.
-
RE: Nozzle crashes before print starts.
Do you have a config override file?
If you do check to see if it has any bed offsets saved there. If it does comment them out an see if it solves the issue and let me know.
-
RE: Dave's so proud
We will be patiently waiting for your fork with all of the fixes, Sunshine