Wanted to build a Morgan so instead of trying to convert the pipes used in it I built my frame from 2020 rail and made by own bearing blocks and some other bits.
Best posts made by Phospherus
-
Parallel Scara based on Morgan.posted in My Duet controlled machine
-
RE: Parallel Scara based on Morgan.posted in My Duet controlled machine
First printing with the Scara looking good so far. No z endstop so set it with piece of paper and no heated bed as my PSU mount is printing so running off a 5 amp 24V power pack. Using a Bondtech BMG for bowden drive with a Phaetus BMO hotend. Link to youtube video below. This is my first time ever uploading to youtube so if it does not work I apologize and will fix it.
-
RE: Parallel Scara based on Morgan.posted in My Duet controlled machine
A couple pictures of the first print complete. I am amazed how good it came out without part cooling even.
-
RE: Compiled Firmware with 5bar-Scara / Dual-Arm-Scaraposted in Firmware installation
@oliof Thank you. I went ahead and tried 3.4.5 and have my Morgan style moving and all looks correct. Still need to install bed and hot end.
-
RE: Parallel Scara based on Morgan.posted in My Duet controlled machine
Finally got a test set of arms printed and a mount for the Nema 17 harmonic drives. Here it is in action. https://youtube.com/shorts/bj47uQ08zV0?feature=share
-
DIY Serial Scara build.posted in My Duet controlled machine
Serial scara build with 125mm arms and linear rails for Z axis. Waiting on hot end heater cartridge and 4010 blower fan and will have it printing