Topics created by nikos

@jay_s_uk Your solution is the way it works right now. But when I will be able to configure it with simple logic it will allow me make it full independent from user.

@nikos said in termocouple connection:

I have a printer with difrent axes sizes depends of configuration and prosses. Is there a way to configure 2 mechanical endstop on the both ends of phisical axes. On min and max. And depends of gcode home to min or max.

You can connect two endstop switches, but moly one switch er axis can be active during homing. You can change which one using the M574 command.

If there are large configuration changes between the two machine configurations, then it may be simplest to set up two separate configuration folders in /sys and use the M505 command to switch between them. If the changes are smaller, you may prefer to use conditional GCode within the files that need to behave differently depending on the machine configuration.

@dc42 Exactly! I'm referring to it "Filename too long" when connected in access Point Mode. We are currently preparing a "migration" to RRF 3.x but it wont be ready until several weeks.
I would like to give a quick solution to mi clients.
One of them answered me that he doesn't use Kaspersky AV....
Thanks for your support !
Simon

Do you know what the VIN coupler shorted to?

As your Duet is responding apparently normally, I think it's most unlikely that it has a fault that would damage a connected DueX5.